How do change the spark plugs on an 92 acura legend? Theres

How do change the spark plugs on an 92 acura legend? Theres no spark plug wires.?
I'm trying to eliminate a "shake" I get from the engine on occasion at redlights. It just one little shutter about 1x per minute. It drives, revs, and accelerates good. any other ideas?

thanks

change the plugs by taking it to your mechanic
he will know what to do
get ngk platinums too

maybe you got a diesel

it most likely is the plugs in it,that a common problem with those,the coil packs set over the plugs with a short wire,good luck.

Pull hard. The bottom of the cap makes a vacuum over the top of the plug. may help to rotate the cap 90 degrees. Once the screws are out and the wire is unclipped, it should pull straight out.

How to really remove it?
Easy . there's one ignition coil FOR EACH SPARK PLUG in this engine six total You remove the two 10mm nuts holding each coil to the head cover, then the coils just lift right out. The spark plug is down in a well under its coil. you'll see the top of the spark plug after that plug's coil is removed. There are three on each side. The drivers side may have a metal brace bar in the way. Unbolt this to get to the back coil and spark plug. Note that they are Platinum plugs and aren't cheap. Use only the correct Acura suggested plugs. they're good for 60000 miles under normal use presuming the engine is in good form. You need a regular deep well spark plug socket tool to take off and install them. Caution: This engine has aluminum heads. don't cross thread the plugs or you'll have a big costly problem. Also don't remove them while engine is hot. You may want to blow out the dirt from the wells before taking the plugs out too, so nothing gets into the cylinders. Put a drop of oil or anti seize on the threads of the new plugs. Makes them easier to get out next time.

you have a cracked Vacuum line some where that isn't far gone still but do to change in the temp and engine vacuum it comes and goes