I can not open the front hood of my 1999 Acura 2.3 CL, what

Acura CL, Integra, Acura Legend, MDX, Acura TL, RSX, TSX, RDX, RL, CSX, Vigor, SLX, NSX...

I can not open the front hood of my 1999 Acura 2.3 CL, what

Postby FredyH » Wed Oct 03, 2007 11:49 am

I can not open the front hood of my 1999 Acura 2.3 CL, what am I supposed to do?
I have WD 40ed the silver latch in the center under the front hood after popping it, still it still will not budge. I have been using the car for the last three months, it used to be used by my brother. He told me he never had such a problem. This small problem is causing a big headache.
User avatar
FredyH
Mentor
 
Posts: 4608
Joined: Tue Nov 21, 2006 11:35 am
Location: Reno Nevada

I can not open the front hood of my 1999 Acura 2.3 CL, what

Postby Marcello » Wed Oct 03, 2007 11:49 am

9 months ago
I can pop the hood from inside my car, THAT isn't THE PROBLEM.

Once the hood is popped, I can not get it completely open because the latch located UNDER THE HOOD, doesn't move.
User avatar
Marcello
Mentor
 
Posts: 4533
Joined: Thu Nov 16, 2006 2:09 pm
Location: Aurora Illinois

I can not open the front hood of my 1999 Acura 2.3 CL, what

Postby Tams » Wed Oct 03, 2007 11:49 am

attempt opening the rear hood
User avatar
Tams
Mentor
 
Posts: 4705
Joined: Sat Nov 18, 2006 8:50 am
Location: Buffalo, ny

I can not open the front hood of my 1999 Acura 2.3 CL, what

Postby hardmanjazz » Wed Oct 03, 2007 11:49 am

You may have to increase the front of the car, but 1st see if the pull handle is broken and the cable is sticking out, if you may be able to see it use a pair of pliers and pull the cable that should release the hood . If the handle is OK but the hood do not release then have someone pull the handle and with the palm of your hand hit the hood near the center of the hood not to hard you may dent it the hood should pop open. If not with the car raised somewhat remove the lower plastic cover you'll have to reach up under the hood area from the bottom and attempt to pull the cable or with a screw driver push the release handle and ot should release the hood, when its open lube the parts and turn the two rubber bumpers on each side of the where the hood closes and that should crack the open problem, Good Luck and GOD Bless
User avatar
hardmanjazz
Mentor
 
Posts: 4575
Joined: Fri Nov 10, 2006 3:18 pm
Location: LA-USA

I can not open the front hood of my 1999 Acura 2.3 CL, what

Postby LeviBrawn » Wed Oct 03, 2007 11:49 am

Try closing the hood tightly till you may be able to hear an audible "CLICK"
as the latch snaps into place. Then start your "hood popping" exercise over again to see if you may be able to repeat the normal hood release procedure. on occasion the latch comes loose from its mounting or on occasion it can break, so get down on your knees with a flashlight and look under the hood for any kind of latch problem, like maybe a broken release cable.
User avatar
LeviBrawn
Mentor
 
Posts: 4558
Joined: Tue Oct 31, 2006 8:42 pm
Location: Fremont, Ca, US

I can not open the front hood of my 1999 Acura 2.3 CL, what

Postby IlloderEr » Wed Oct 03, 2007 11:49 am

get a new car
User avatar
IlloderEr
Mentor
 
Posts: 4581
Joined: Fri Nov 24, 2006 7:55 am
Location: Rochester, New York, usa

I can not open the front hood of my 1999 Acura 2.3 CL, what

Postby ia2lyte » Wed Oct 03, 2007 11:49 am

if you look closey you may be able to see a hook that is shap like the letter "r". attempt to get a screw driver and pry it to the left or right based on which way the "r" is facing,
User avatar
ia2lyte
Mentor
 
Posts: 4651
Joined: Mon Nov 06, 2006 6:32 pm
Location: El Paso TX

Postby PedroFor » Wed Oct 22, 2008 11:05 pm

:)
PedroFor
Member
 
Posts: 26
Joined: Wed Oct 22, 2008 10:59 pm

Postby PedroFor » Wed Oct 22, 2008 11:06 pm

:D
PedroFor
Member
 
Posts: 26
Joined: Wed Oct 22, 2008 10:59 pm


Return to Acura Forum

Who is online

Users browsing this forum: No registered users and 0 guests