| Author |
Message |
pharx
Mentor
Joined: 10 Nov 2006
Posts: 4695
Location: Birmingham AL |
|
 Installing a locking hub on a 2000 Ford F250? |
 |
The locking hub is missing now and I have to replace it. Do I have to take off the complete hub to replace it or can it be put on without removing the wheel, caliper and rotor? This specific locking hub doesn't have any screws or bolts on it. it's just a black handle. Thanks
|
|
| Sat Sep 22, 2007 6:01 pm |
   |
 |
JonnLee
Mentor
Joined: 27 Nov 2006
Posts: 4688
Location: San Jose,California |
|
| Installing a locking hub on a 2000 Ford F250? |
|
yes leve 2.
|
|
| Sat Sep 22, 2007 6:01 pm |
|
|
Bobby_Mun17
Mentor
Joined: 16 Oct 2006
Posts: 4634
Location: plano TX |
|
| Installing a locking hub on a 2000 Ford F250? |
|
There is a big spring clip on the outside of the hub sandwiched between the hub and the rotor
|
|
| Sat Sep 22, 2007 6:02 pm |
|
|
nzeeman
Mentor
Joined: 23 Sep 2006
Posts: 4572
Location: Chicago USA |
|
| Installing a locking hub on a 2000 Ford F250? |
|
You don't have to remove the wheel But you have to remove the center cap if equipped. Use a needle nose pliers and squeeze two tabs together that point towards you when looking at it. Then pull external on two tabs and you'll have the big snap ring in your hand. Then you have to pull and pry on hub till it slides out on occasion stuck in there pretty good . Slide in new hub and push in snap ring till snaps into place.
|
|
| Sat Sep 22, 2007 6:02 pm |
|
|
|
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
|
Contact Us Store |
Privacy Policy: Car Forum World Does not store any information about its visitors
|
