Bronco, Diesel, Escape, Expedition, Ford Explorer, F150 Truck, Ford Focus, Fusion, GT, Mustang, Ford Probe, Ranger, Sierra, ZX2...
by 6pack » Sat Sep 22, 2007 5:53 pm
where is the vacuum modulator located on a 1991 caprice classic?
-

6pack
- Mentor
-
- Posts: 4623
- Joined: Sun Nov 19, 2006 5:14 pm
- Location: Baton Rouge Louisiana
by Mohawk » Sat Sep 22, 2007 5:53 pm
you may want to be asking the chevie people, this is the Ford corner. but I do not think they have used one of those in years :
-

Mohawk
- Mentor
-
- Posts: 4542
- Joined: Fri Nov 10, 2006 6:31 pm
- Location: Memphis
by ProgrammerX » Sat Sep 22, 2007 5:53 pm
it do not have one,its all computer controlled now,they have not used modulators on transmissions in years now,good luck I hope this help,s.
-

ProgrammerX
- Mentor
-
- Posts: 4621
- Joined: Mon Oct 16, 2006 8:36 am
- Location: Portland oregon
by Jackson A. » Sat Sep 22, 2007 5:53 pm
Should be on the transmission. The vacuum line runs from the carb down to the tranny.
-
Jackson A.
- Mentor
-
- Posts: 4446
- Joined: Wed Nov 29, 2006 12:34 pm
- Location: New York ny
by Buduwoodoo » Sat Sep 22, 2007 5:53 pm
list time I looked it was on the back of the trans by the out put shaft.
-

Buduwoodoo
- Mentor
-
- Posts: 4615
- Joined: Thu Nov 16, 2006 2:19 am
- Location: Tacoma,Washington
by VrunGert » Sat Sep 22, 2007 5:53 pm
The vacuum modulator is on the right rear of the transmission near the rear of the service pan, just follow the vacuum line from the engine and you'll find it. it'll be a brass color with painted rings around it probably blue or yellow, to check it just pull the hose off and look for liquid, if its wet replace it make sure not to loose the short pin that will be at the end of it. Good luck and GOD Bless
-
VrunGert
- Mentor
-
- Posts: 4692
- Joined: Tue Nov 28, 2006 6:24 pm
- Location: Jacksonville, Florida
Return to Ford Forum
Who is online
Users browsing this forum: No registered users and 0 guests